Redmax HEZ2460S Instrukcja Użytkownika Pobierz pdf (Strona 14)

Maintenance, replacement, or repair of the emission control device and systems may be performed by any

non-road engine repair establishment or individual.

• Always be sure to stop the engine before inspecting the stick edger for problems or performing

maintenance.

•Never alter the stick edger or take the engine apart.

•When replacing parts, always be sure to use only RedMax products or products which have been

certified by RedMax for use with the RedMax stick edger.

WARNING

■ BE SURE TO CHECK THE FOLLOWING BEFORE USING YOUR STICK EDGER

US-14

HEZ2460S/HEZ3060S

9. Maintenance

every every every

25 50 100

system/compornent procedure before hours hours hours note

use after after after

fuel leaks, fuel spillage wipe out ✔

fuel tank, air filter, fuel filter inspect/clean ✔✔ replace, if necessary

see ■ADJUSTING replace carburetor

idle adjusting screw ✔

IDLING SPEED (p.13) if necessary

GAP: .025in(0.6~0.7mm) (HEZ2460S)

spark plug ✔ GAP: .037in(0.9~1.0mm) (HEZ3060S)

replace, if necessary

cylinder fins, intake air cooling vent clean ✔

muffler, spark arrester, cylinder exhaust port

clean ✔

throttle lever, ignition switch check operation ✔

replace if

cutting parts ✔

something's wrong

drive shaft grease ✔

gear case grease ✔

screws/nuts/bolts tighten/replace ✔✔not adjusting screws

cutting blade inspect/replace ✔ replace, if necessary

ENGINE

SHAFT

■ MAINTENANCE CHART

Item to be checked Response

1 Edging mechanism • See if attachment is loose • Tighten screws and bolts

• Check if edges of blades are dull • Sharpen or replace blades

2 Throttle • Stiff and difficult to move • Repair or replace

3 Throttle wire • Too loose, too tight • Adjust

• Stiff and difficult to move • Repair or replace

4 Engine attachment • See if fittings are loose • Tighten fittings

5 Fuel tank • See if attachment is loose • Tighten screws and bolts

• See if fuel pipe is damaged • Replace

• See if cap packing is damaged • Replace

6 Muffler • See if attachment is loose • Tighten screws and bolts

7 Cutting blade • See if damaged or worn shorter than usable • Replace

length

clean and readjust

plug gap

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Komentarze do niniejszej Instrukcji

Brak uwag

Modelle	Dokumententyp
Drawer Organizer-Wood	Bedienungsanleitung Ronbow Drawer Organizer-Wood User Manual, 2 Seiten
Metal Feet	Bedienungsanleitung Ronbow Metal Feet User Manual, 1 Seiten
Motion Sensor LED Light	Bedienungsanleitung Ronbow Motion Sensor LED Light User Manual, 4 Seiten

Redmax HEZ2460S Instrukcja Użytkownika Strona 14

Komentarze do niniejszej Instrukcji

Ronbow Software Benutzerhandbücher